Pengo Computer Accessories UBR7200 Pppoe-forwarding, Usage Guidelines Examples Related Commands

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

pppoe-forwarding

pppoe-forwarding

To enable PPP over Ethernet forwarding on the router, use the pppoe-forwardingglobal configuration command. To disable PPPoE forwarding on the router, use the no form of this command.

pppoe-forwarding

no pppoe-forwarding

Syntax Description This command has no arguments or keywords.

Defaults By default PPPoE forwarding is disabled (no pppoe-forwarding).

Command Modes

Command History

Global configuration

ReleaseModification

12.1(3)XQ1 This command was introduced.

Usage Guidelines

Examples

Related Commands

The pppoe enable command and the pppoe-forwardingcommand cannot be configured at the same time. You can configure only one or the other at any given time.

The following example shows how to set PPPoE forwarding on the radio interface:

Router(config)# pppoe-forwarding

Command	Description
pppoe enable	Enables PPPoE termination on the radio interface.
pppoe-forwarding	Enables PPPoE forwarding on the router.
forwarding	Sets all packets received on the radio interface with a single
default-qos-level	quality-of-service (QoS) level.
forwarding group	Sets a PPPoE forwarding group number on the radio interface.
su-mac	Specifies the subscriber unit MAC address that is mapped from the radio
	interface to the virtual circuit (VC) on the ATM interface for PPPoE
	forwarding.
tag	Specifies the subscriber unit tag name that is mapped from the radio
	interface onto the VC on the ATM interface for PPPoE forwarding.

Cisco IOS Release 12.1(5)XM

29