Pengo Computer Accessories UBR7200 manual Verifying the Wireless Modem Card Configuration

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

Monitoring and Maintaining Multipoint Wireless Configurations

	Command	Purpose
Step 4
	Router(config-if)# end	Exits the interface configuration mode and get to
		the EXEC mode.
Step 5
	Router# show interface radio slot/port alc	Displays the ALC setting that you specified.

Verifying the Wireless Modem Card Configuration

Step 1 Enter the show running-configurationcommand in privileged EXEC mode to display the configuration currently in effect on the Cisco uBR7200 series.

Step 2 Enter the show startup-configurationcommand in privileged EXEC mode to display the system startup configuration.

For a complete list of commands to verify the installation and configuration of your fixed wireless multipoint system, see the “Verification Commands”section.

Monitoring and Maintaining Multipoint Wireless Configurations

This section describes the clear and show commands that are used to monitor and maintain the multipoint fixed wireless system. For a complete list of commands to monitor and maintain your fixed wireless multipoint system, see “Monitoring Commands” under the command reference section. For the syntax and description of a command, refer to the “Command Reference” section of this document.

Command		Purpose
Router# clear radio flap-list		Clears the current radio flap-list entries for a
		specific subscriber unit or for all subscriber units.
Router# clear radio link-metrics		Clears the link metrics settings.
Router# clear radio subscriber counters		Clears the counters for a radio modem or all radio
		modems in the Station Maintenance List.
Router# clear radio subscriber reset		Resets the radio modem or all radio modems on the
		network.
Router# show controllers radio downstream		Displays downstream port information for a
		wireless modem card.
Router# show controllers radio if		Displays the IF hardware information for the
		specified radio interface.
Router# show controllers radio rf		Displays the RF hardware information for the
		specified radio interface.
Router# show controllers radio upstream		Displays upstream port information for a wireless
		modem card.
Router# show interfaces radio metrics		Displays the parameters measured during the
		operation of the radio link.
Router# show interface radio accounting		Displays radio accounting information for a
		wireless modem card.
	Cisco IOS Release 12.1(5)XM

12