Pengo Computer Accessories UBR7200 manual Show interface radio tl-data, 139

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

show interface radio tl-data

show interface radio tl-data

To display the timeline data collected for the identified specifications, use the show interface radio tl-dataprivileged EXEC command.

show interface radio slot/port tl-data[statsParams {MAC-address chan-id}]

Syntax Description

Defaults

Command Modes

Command History

slot/port	The slot and port numbers of the radio card.
statsParams	{sinr-ant1 sinr-ant2 sinr-total timingOffset rf-rx-power-ant1
	rf-rx-power-ant2 chan-delay-spread-ant1
	chan-delay-spread-ant2 power-amb}
	The data for the radio attribute is collected as a histogram.
sinr-ant1	Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2	Signal-to-interference plus noise ratio for antenna 2.
sinr-total	Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset	Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1	Represents the receive power at the main RF headend (antenna gain
	is not included).
rf-rx-power-ant2	Represents the receive power at the diversity RF headend (antenna
	gain is not included).
chan-delay-spread-ant1	The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2	The offset for channel delay spread on antenna 2.
power-amb	Represents the noise floor of the ambient environment, in decibels.
MAC-address	Specifies the MAC address for a particular subscriber unit.
chan-id	Specifies an upstream channel ID.
No default behavior or values.
Privileged EXEC

ReleaseModification

12.1(3)XQ1 This command was introduced.

Examples	The following example shows how to display the timeline data for sinr-ant1on channel 0 for the radio
	card in slot 6, port 0:
	Router# show int radio 6/0 tl-data sinr-ant1 0

Cisco IOS Release 12.1(5)XM

139