Pengo Computer Accessories UBR7200 manual Radio timeline, Print-options On or off

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio timeline

radio timeline

To configure a timeline collection specification, use the radio timeline interface configuration command. To delete a timeline, use the no form of this command.

radio timeline statsParams {MAC-address chan-id}size [dsp dspNum] [print-options{on off}] [sampling-period] [tone {circular average number toneVal}]

[Trigger threshParams threshType postTrigBufmgt]

no radio timeline statsParams {MAC-address chan-id}

Syntax Description	statsParams	{sinr-ant1 sinr-ant2 sinr-total timingOffset rf-rx-power-ant1
		rf-rx-power-ant2 chan-delay-spread-ant1
		chan-delay-spread-ant2 power-amb}
		The data for the radio attribute is collected as a histogram.
	sinr-ant1	Signal-to-interference plus noise ratio for antenna 1.
	sinr-ant2	Signal-to-interference plus noise ratio for antenna 2.
	sinr-total	Signal-to-interference plus noise ratio for antennas 1 and 2.
	timingOffset	Represents the timing delay variations detected in the radio link.
	rf-rx-power-ant1	Represents the receive power at the main RF headend (antenna gain
		is not included).
	rf-rx-power-ant2	Represents the receive power at the diversity RF headend (antenna
		gain is not included).
	chan-delay-spread-ant1	The offset for channel delay spread on antenna 1.
	chan-delay-spread-ant2	The offset for channel delay spread on antenna 2.
	power-amb	Represents the noise floor of the ambient environment, in decibels.
	MAC-address	Specifies a particular subscriber unit.
	chan-id	Specifies an upstream channel ID. Valid values are 0 to 3.
	size	Specifies the number of values to be collected.
	dsp	Specifies one of the following digital signal process (DSP) dspNum
		values: dsprx0, dsprx1, dsprx2, or dsprx3.
	print-options	on or off.
	sampling-period	Specifies, in seconds, the frequency of data collection.
	Trigger	Specifies when the collection of data must stop. Trigger identifies a
		threshold specification. When the threshold is reached, the timeline
		collection is stopped.
	threshParams	Has same attributes as statsParams.
	threshType	{high-thresh low-thresh up-change down-change
		pos-crossing neg-crossing}
	high-thresh	Specifies that the threshold condition is met when the value being
		monitored is above threshValue.
	low-thresh	Specifies that the threshold condition is met when the value being
		monitored is below threshValue.
	up-change	Specifies that the threshold condition is met when the positive change
		of the value being monitored is greater than threshValue.

Cisco IOS Release 12.1(5)XM

98