Pengo Computer Accessories UBR7200 manual Radio threshold

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio threshold

radio threshold

To configure a threshold specification, use the radio threshold interface configuration command. To delete a threshold specification, use the no form of this command.

radio threshold statsParams {MAC-address chan-id}threshType threshValue [repeat-time][clear-time] [dsp dspNum]

no radio threshold statsParams threshType

Syntax Description	statsParams	{sinr-ant1 sinr-ant2 sinr-total timingOffset rf-rx-power-ant1
		rf-rx-power-ant2 chan-delay-spread-ant1 chan-delay-spread-ant2
		power-amb}
	sinr-ant1	Signal-to-interference plus noise ratio for antenna 1.
	sinr-ant2	Signal-to-interference plus noise ratio for antenna 2.
	sinr-total	Signal-to-interference plus noise ratio for antennas 1 and 2.
	timingOffset	Represents the timing delay variations detected in the radio link.
	rf-rx-power-ant1	Represents the receive power at the main RF headend (antenna gain is not
		included).
	rf-rx-power-ant2	Represents the receive power at the diversity RF headend (antenna gain is
		not included).
	chan-delay-spread-ant1The offset for channel delay spread on antenna 1.
	chan-delay-spread-ant2The offset for channel delay spread on antenna 2.
	power-amb	Represents the noise floor of the ambient environment, in decibels.
	MAC-address	Specifies a particular subscriber unit.
	chan-id	Specifies an upstream channel ID. Valid values are 0 to 3.
	threshType	{high-thresh low-thresh up-change down-change pos-crossing
		neg-crossing}
	high-thresh	Specifies that the threshold condition is met when the value being
		monitored is above threshValue.
	low-thresh	Specifies that the threshold condition is met when the value being
		monitored is below threshValue.
	up-change	Specifies that the threshold condition is met when the positive change of
		the value being monitored is greater than threshValue.
	down-change	Specifies that the threshold condition is met when the negative change of
		the value being monitored is greater than the threshValue.
	pos-crossing	Specifies that the threshold condition is met when the value being
		monitored does a positive crossing (positive increase) of the threshValue.
	neg-crossing	Specifies that the threshold condition is met when the value being
		monitored does a negative crossing (negative increase) of the threshValue.
	threshValue	A 32-bit integer value.
	repeat-time	Identifies how much time is left before another event of the same type is
		generated when oscillating across a threshold.

Cisco IOS Release 12.1(5)XM

96