
Countertop Rotisserie Oven | Operation |
2.Select the desired program by pressing the ITEM SELECT button until the LED corresponding to the desired program is illuminated.
3.When the controller reaches the programmed temperature, the display will alternate between “rEdy” and the current oven temperature. The audible alert will also sound for five (5) seconds. The audible alert may be canceled early by pressing the START/STOP button. The display will continue to flash the ready message.
During the ready message, the operator may also change to a new program. Since each program may be set for a different temperature, the controller may require a
Once the display shows “rEdy”, if the oven temperature falls out of range again (due to the door opening to load product), the “too Hot” or “too CooL” message will not be displayed. The “too Hot” or “too CooL” messages are disabled during a cycle.
4.Open the oven door and load the product. Use the ROTOR CONTROL switch on the front panel to operate the rotor during loading.
5.Once the product is loaded, close the door.
6.When the display is flashing the ready message and you want to start the cook cycle, press the START/STOP button.
7.When a cook cycle ends, do one of the following:
•If a hold time/temperature has not been programmed, an alarm will sound and the display will flash the message “donE” until a button is pressed. Press the START/STOP button to enter the stop mode.
•If a hold time/temperature has been programmed, the hold cycle will start. During the hold cycle the oven temperature will be regulated to the programmed hold temperature setting. When the accumulated hold time reaches the hold time setting, an alarm sounds and the display will flash the message “HoLd donE” until a button is pressed. Press the START/STOP button to enter the stop mode.
Power Failure During Cooking Cycle
The controller will suspend operation retaining programs and cycle times. When power is restored, operation will resume where left off when power failed.
Probe (Thermocouple) Diagnostics
If the probe (thermocouple inside the oven) stops working, the controller will cancel the cooking cycle, an audible alert will sound, and the display will show “PROB”.
10