Bakers Pride Oven VHVA1620E, VH1620E Single-Phaseconnection, Three Phase Connection, Nema Specs

Field Connections

NOTE: VERIFY THAT INPUT POWER MATCHES THE OVEN POWER REQUIREMENTS STATED ON THE RATING PLATE, WHICH IS LOCATED ON THE POWER CONTROL BOX.

IF INPUT VOLTAGE DOES NOT MATCH OVEN VOLTAGE REQUIREMENTS, THE CORRECT CONVEYOR OVEN MUST BE INSTALLED. THE CONVEYOR OVEN CANNOT BE MODIFIED IN THE FIELD TO MATCH INPUT POWER.

CAUTION: FOR 3 PHASE UNITS ONLY: VERIFY VOLTAGE OF EACH LEG. IF ANY LEG HAS A VOLTAGE GREATER THAN 240V THIS LEG MUST BE CONNECTED TO L-3 ON THE POWER DISTRIBUTION BLOCK.

FOR DUAL AIR MODELS VH1620E, VHVA1620E:

These units are supplied with a flexible power cord, according to the specification placed with the original order, which specified either single-phase or three-phase operation. No internal field connection is necessary. All internal connections are complete. Connect the power cord to the proper power receptacle. (see diagram below).

Note: If a different power cord is required than supplied, the correct power cord must be obtained from a factory authorized service agent. Only an authorized service agent is to replace a power cord.

FOR DUAL AIR MODELS VH1828E, VHVA1828E:

a)Remove the cover from the Power Distribution Box Panel (under the control box on right side when facing front of unit).

b)Locate the 4-pole Power Distribution Terminal Block mounted in the Power Distribution Box.

c)Install the proper strain relief for the PERMANENT CONNECTION utilizing the knock-out hole provided. The strain relief should be securely fastened.

d)Supply the proper conduit to the conveyor oven and connect through the strain relief. Connect properly-sized, copper-only conductor wires (rated 90°C) to the Power Distribution Terminal Block in accordance with the schematic shown on the rating plate, as well as the wiring diagram provided. NOTE: For three-phase connections, if any “High Voltage Leg” conductor is present, it MUST be mounted to L3 ONLY. Replace the cover and fasten securely with removed screws.

SINGLE-PHASE CONNECTION

WIRINGFIELD CONNECTIONSSERVICE	G	G4	WIRINGFACTORY	CIRCUITSINTERNALTO
	L3
		L2
	L2	5
		R (BROWN)
		L2
		L2
	L1	4
		E (BROWN)

A

7

THREE PHASE CONNECTION

WIRINGFIELD CONNECTIONSSERVICE	G	G4	WIRINGFACTORY	CIRCUITSINTERNALTO
		E (BROWN)
	L3	R (BROWN)
		L2
	L2	5
		L2
		L2
	L1	4
		A

NEMA SPECS.

1620E 1 PHASE

1620E 3 PHASE

6-50P

L15-30P