AC POWER CONNECTIONS
These terminal block connections are used to interface the wires/cables from the emergency power supply input terminals located inside the transfer switch.
BATTERY CHARGER CONNECTIONS (OPTIONAL)
If you purchased a Master Control Systems Inc. Battery charger with your generator set you must run two sets of wires from the battery charger to the generator set.
UNITS WITH FACTORY INSTALLED ENCLOSURE
The terminal block that contains the connection points for the remote start on the enclosed units also contains the connection points for interfacing the battery charger to the generator set.
The wires from the terminals labeled DK1 and DK2 on the battery charger go to the D1 and D2 terminal connection points on the terminal block pictured in figure 3.
The wires from the terminals labeled B+ and B- on the battery charger go to the POS and NEG terminal connection points on the terminal block pictured in figure 3.
Page 14 of 45
