OPERATION
PRIOR TO STARTING THE UNIT:
1.Locate and set up the generator set in an open, dry, well ventilated and reasonably level location.
OPERATING THIS UNIT IN AN AREA NOT SUITABLE FOR IT'S PROPER USE MAY CAUSE DAMAGE TO THE UNIT, SEVERE INJURY, OR DEATH. SEE "LOCATION INFORMATION" SECTION LOCATED ELSEWHERE IN THIS MANUAL.
2.If grounding is required for your application, check to make sure your unit is grounded properly.
3.Check the engine's oil level and add whatever amount of oil is necessary to bring it up to the level that is recommended by the engine manufacturer.
4.Check the fuel system for fuel leaks.
5.Make sure all circuit breakers are set (pushed In).
CONTROLS AND THEIR FUNCTIONS
Master Control Switch:
This switch is a three position toggle switch which allows the user to choose the automatic or manual mode of operation.
The center position is the off position.
By putting this switch in the OFF position the generator set will not start under any conditions.
To reset the control logic after a fault has occurred, this switch must be put into the Off position for a minimum of 10 seconds.
Run/Manual Mode: When the Master Control Switch is put into this position it immediately energizes the crank cycle to start the generator set. The generator set will continue to produce power until the Master Control Switch is put into the 'OFF' position or until a fault condition develops.
Page 22 of 45
