Bally Refrigerated Boxes Refrigerators/Freezers/Warmers Casters Must Be Tight To Cabinet Bottom

Important Note: It is extremely important that your new reach-in or roll-in model is perfectly level for proper operation. If it is not level, the following adverse conditions will become apparent:

1.The door(s) will not be properly aligned and consequently will not provide a good seal. Roll-in door wiper(s) may bind.

2.Your model will run excessively due to improper door seal(s).

3.An excessive amount of ice will accumulate inside the cabinet, around the door opening(s) and especially on the finned evaporator coil. If allowed to continue,

ice will eventually block the coil and the model will fail. This will	result in the
loss of all food stored within the cabinet.

4.Defrost water will fail to drain properly and will overflow the evaporator coil drain pan and into the cabinet of both refrigerator and freezer models.

INSTALLING CASTERS AND LEVELING REACH-IN MODELS

If you wish to install casters on your new reach-in model, follow the steps above for "installing legs" to install the casters, making sure again that the casters are tightened extremely well (see figure 3). If the casters are not installed tightly, the cabinet will sway or rock with each opening or closing of the doors, possibly causing damage to the case bottom.

To assure that your cabinet is level, caster cups must be installed under the casters which need leveling. Caster cups are not provided with your new model but can be purchased at most hardware or furniture stores. Do not attempt to level casters by unscrewing them from the case bottom as this will cause damage to the cabinet bottom and leg hole threads, voiding all warranties.

FIGURE 3

CASTERS MUST BE TIGHT TO CABINET BOTTOM

- 5 -