Baracoda BLR2604, BL2604, BC2604 Data editing, Prefix and suffix, Barcode identifier code setting

BC/BL/BLR2604 Programming Guide

6Data editing

Start of Configuration

6.1Prefix and suffix

This option allows you to append a prefix and/or a suffix to every message transmitted. There is no restriction in selecting prefix or suffix characters as far as the sum of the lengths of prefix and suffix is not greater than 10 digits.

You must enable prefix/suffix with the BaracodaManager previously to configurate prefix and/or suffix (see 2604 protocol or BaracodaManager document)

1.Select either prefix or suffix you are going to program by scanning the corresponding

Prefixlabel

2.Scan the character(s) you want from the enclosed

ASCII table to set as prefix or

Suffixsuffix (be sure to enable full ASCII code 39 option before you start).

Set	3. Read the “Set” label to set
	your choice into memory.

6.3Barcode identifier code setting

Each of the series type scanners can set max.2 digits as barcode identifier code according to different barcode. The procedure is as follows:

1.Scan “Start of configuration” label

2.Scan “Barcode identifier setting code” label.

3.Scan the new code mark from ASCII table (max. two digits). For example, if one “AB” want for code mark then scan “A” and “B”.

4.Scan “Set” label.

5.Scan “ End of configuration” label.

UPC-E

UPC-A

EAN-13

EAN-8

Chinese post code

6.2Barcode identifier code selection

The scanners can transmit max.2-digit barcode identifier code for different types of barcodes. Use the labels to choose transmit or not transmit predefined barcode identifier code (ID’s are listed on section 1):

Enable

Disable

© Baracoda 2004

ITF 2 OF 5

Coda bar

Code 39

Code 128

Page 17/22