Power Connection
6 | POWER CONNECTION |
|
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector at the front of the projector.
|
| See installation instructions before | ||
|
| connecting to the supply | ||
|
|
| V NOM 120 Volt | |
|
|
| I MAX | 5 AMP |
|
| OFF ON | FREQ | 60 Hz |
See installation instructions before |
|
| ||
connecting to the supply |
|
| ||
| V NOM 120 Volt |
|
| |
| I MAX | 5 AMP |
|
|
OFF | FREQ | 60 Hz |
|
|
ON |
|
|
| |
Fuses
Warning
For continued protection against fire hazard :
-replace with the same type of fuse
-refer replacement to qualified service personnel
Fuse type : 2 x T5A/250V (Barco order number : R314104)
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image dis- played) or in the 'stand by mode', depending on the position of the 'power up' dip switch on the controller unit. This DIP switch is set during installation by a qualified technician. If you want to change this start up mode, call a qualified technician.
Leds on the front plate of the projector
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
+9V +17V | +210V | STANDBY | HOLD DOWN EHT | SF | COINC | HOLD DOWN HD |
5975987A BARCODATA 708 260597 |
| |
|
