G2 Adjustment
A G2 ADJUSTMENT
G2 adjustment
Enter the adjustment mode by pressing ADJUST and highlight Service. Press ENTER to start up the service mode.
Highlight 'Common settings' and press ENTER.
ENTER starts up the Common settings menu.
EXIT returns to the adjustment mode menu.
Highlight G2 adjust and press ENTER.
A safety notice will be displayed to warn the operator.
If you are qualified, press ENTER to continue with the G2 adjust- ment, otherwise press EXIT to return to the service menu.
If ENTER is pressed, the G2 menu will be displayed.
ADJUSTMENT MODE
Select a path from below:
GUIDED
RANDOM ACCESS 
INSTALLATION
SERVICE
IRIS
source 1
SERVICE MODE
PROJECTOR
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with 
or then <ENTER> <EXIT> to return.
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
SAFETY
NOTICE
RISK OF ELECTRICAL SHOCK
G2 ADJUSTMENT SHOULD BE
PERFORMED
BY BARCO PERSONNEL,
OR BARCO AUTHORIZED
DEALERS.
IF QUALIFIED, PRESS <ENTER> TO CONTINUE, OR IF NOT, <EXIT> TO RETURN.
131 |
G2 ADJUSTMENT |
Use the potentiometers |
on the |
toset the screen grid |
voltage for Red, |
Green and Blue. |
Adjust until the LED |
on the corresponding |
output amplifier is turned off |
<EXIT> to return. |
5975987A BARCODATA 708 260597 |
| |
|
