Bard Q24A1, Q30A1 Q-TEC Series General Information, Q 42 A, X X V X X, Q-Tec Model Nomenclature

Q-TECSeries General Information

Q-TECMODEL NOMENCLATURE

Q 42 A 1

A10

X X V X X X

MODEL NUMBER Q-Tec™

CAPACITY

24 - 2 Ton

30 - 2½ Ton

36 - 3 Ton

42 - 3½ Ton

48 - 4 Ton

60 - 5 Ton

AIR

CONDITIONER

REVISION

SPECIALTY PRODUCTS 1 (Non-Standard)

VOLTS & PHASE

A - 230/208/60/1

B - 230/208/60/3

C - 460/60/3

KW

0Z - 0KW

05 - 5KW

06 - 6KW

09 - 9KW

10-10KW

12-12KW

15-15KW

FILTER OPTIONS X - 1 inch Fiberglass

(Standard)

F - 2 inch Fiberglass P - 2 inch Pleated

COLOR

V - Platinum w/Slate Front (Vinyl)

X - Beige paint 4 - Gray paint

COIL OPTIONS
	INTERNAL
X -Standard
	CONTROLS
1 -Phenolic coated
	X - Standard
evaporator*
	• High Pressure
2 -Phenolic coated
	Switch
condenser
	• Low Pressure
3 -Phenolic coated
	Switch
evaporator and
	• Compressor
condenser coil*
	Control Module
*and reheat if	w/Time Delay
	J - Alarm Relay +
applicable
	LAC + Above

VENTILATION OPTIONS

X- Barometric Fresh Air Damper (Standard) B - Blank-off Plate

E - Economizer (Not available on dehumidification versions)

P - Commercial Ventilator - Motorized w/Exhaust Power Return V - Commercial Ventilator - Motorized w/Exhaust Spring Return

R - Energy Recovery Ventilator w/Independent Intake & Exhaust Control

CLIMATE CONTROL2

STANDARD UNITS			DEHUMIDIFICATION UNITS
X	- None 2		X - None 2
A	-	Electronic/Non Prog	E	-	Electronic/Prog/Humidistat
D	-	Electronic/Prog	G	-	Electronic Non-Prog/Humidistat
H	-	Electronic/Prog/CO2	I	-	Electronic Prog/Humidistat/CO2

NOTE: 1 Insert “D” for dehumidification with hot gas reheat. Reference 7960-584 for complete details.

2 If “X” control option is selected, then thermostat and humidistat, if applicable, or DDC control system must be field supplied.

Manual	2100-522B
Page	4 of 38