Cleaning the door
oTo clean the edge around the outside of the door, you should use a soft, damp cloth only.
oTo prevent water from penetrating the door lock or electrical components, DO NOT use a spray cleaner of any kind.
oDO NOT use any abrasive cleaner or scouring pads on the inner or outer surfaces, as they may cause damage to them.
Error code failure system
If your appliance senses that it is not operating correctly, then a program indicator light may flash.
The following error codes can possibly be remedied by the customer and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS POWER SUPPLY.
RAPID program indicator flashes.
oLonger than expected fill time.
Check the water pressure of your mains water supply.
Clean the mesh filter that sits in the inlet hose.
Ensure that the inlet hose is not kinked or crushed.
Make sure the water tap that the machine is connected to is turned on fully.
GLASS program indicator flashes.
oThe machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage system that the appliance is connected to.
30
