BBQ Pro BQ04023-2 Type1Connector1, Leak Testing the REGULATOR, VALVES, HOSES, and Connections

Models: BQ04023-2 BQ52006

1 28
Download 28 pages 22.57 Kb
Page 19
Image 19

Theregulatormustenterthe cylindervalvein astraight line.

Center this nipple of the regulator into the cylinder valve.

_.C.C.Type1Connector1

WARNING

1.Do not connect this grill to any unregulated sources of propane.

2. Protect the regulator fitting from damage when disconnected. A damaged regulator fitting may result in a gas leak when connected to a LP cylinder.

3.Inspect the gas hose before each use. Replace the hose assembly before use if you notice any flaying, cracking, or excessive wear.

4.Always pertbrm the Leak Test listed below before using your grill for the first time, if the cylinder

has been changed, any gas components have been changed, the regulator flow-limiting device has been activated, or after a long period of non-use.

5.Do not attempt to connect this grill to the LP system of a motor home or trailer.

LEAK TESTING THE REGULATOR, VALVES, HOSES, AND CONNECTIONS

1.Ensure the LP cylinder valve and all burners are "Off _'.

2.Ensure the LP cylinder is connected to the regulator.

3.Mix up a solution of 50% water and 50% liquid dish soap. Do not use any household cleaner solution.

4.Open the LP tank valve by turning the hand wheel counterclockwise one turn. If you hear a rushing

sound, mm the gas offimlnediately.

In that case, there could be a leak at the connection.

Reconnect

the cylinder to the regulator.

 

 

5.Spray or brush on the solution covering the tbllowing areas: cylinder welds, regulator and cylinder

connection, gas hose connections to the regulator, all gas hoses, all gas hose connections to the burners including the main and side burners.

6.Growing bubbles on any of the parts and connections listed above indicate a gas leak. Immediately

shut offthe LP tank valve by turning the valve clockwise. Retighten the connections or order

replacement parts as needed. Continue to test as necessary until no leaks are detected.

7.Close the LP tank valve by turning the hand wheel clockwise.

'_ WARNING

1.DO NOT USE THE GRILL if you cannot stop a leak. Be sure the LP cylinder valve is closed. If the LP cylinder is still leaking, contact your LP dealer or local fire department.

2.Do not use any match or open flame, or smoke, during leak testing.

3.Do not light a burner during leak testing.

19

Page 19
Image 19
BBQ Pro BQ04023-2, BQ52006 manual Type1Connector1, Leak Testing the REGULATOR, VALVES, HOSES, and Connections