EUROGRAND EG2080-RW/BK

Please note the order of voices used in the sound combination selected, in order to understand which settings apply to which voice in the examples below.

A layer combination consisting of two sounds must be set up before you can adjust the following functions (see chapter 5.1).

6.3.1 Volume ratio

Use this function to adjust the volume ratio of the selected sounds.

Please enter EDIT mode (see chapter 6.1) and select the following function.

Function:E3.1

Value:0x20

Description:

10: Same volume for voice #1 and voice #2

<10: Voice #2 louder than voice #1

>10: Voice #1 louder than voice #2

6.3.2 Detune

This function allows you to detune the selected sounds slightly against each other.

Please enter EDIT mode (see chapter 6.1) and select the following function.

Function:E3.2

Value:-10x10

Description:

0: Same pitch for voice #1 and voice #2

<0: Voice #2 higher than voice #1

>0: Voice #1 higher than voice #2

6.3.3 Transposition

Use this function to transpose the selected sounds up or down by one octave. Depending on which sounds are used in a combination, the tranpose function can help make the sounds more homogeneous.

Example:

In a combination of GRAND PIANO 1 and STRINGS the STRINGS sound too low. In this case, it helps to transpose the STRINGS up by one octave.

Please enter EDIT mode (see chapter 6.1) and select the following function.

Function:E3.3 (voice #1 transposed by an octave)

E3.4 (voice #2 transposed by an octave)

Value:-1x1

Description:

0: No transposition

-1: Transposition down by one octave

1: Transposition up by one octave

6.3.4 Effect intensity

This function allows you to edit the effect intensity of the modulation effect for the selected sounds.

Please enter EDIT mode (see chapter 6.1) and select the following function.

Function:E3.5 (effect intensity voice #1) E3.6 (effect intensity voice #2)

Value:0x20

Description:

1x20: Effect intensity (default setting)

0: No effect

6.3.5 Reset

Use this function to reset all settings in layer mode.

Please enter EDIT mode (see chapter 6.1) and select the following function.

Function:E3.7

Value:-

Description:

Press the +/YES button to execute this function.

6.4 Using the metronome

The EG2080 features a built-in metronome which can be used for practising or to make recordings with the internal music sequencer.

To use the metronome, please proceed as follows :

1)Press the METRONOME button to start or stop the metronome.

The metronome beats are shown by flashing dots on the display. At the beginning of a measure all dots light up simultaneously.

2)Keep pressing the SELECT button in the TEMPO/EDIT MODE section until the TEMPO LED lights up.

3) Use the two ef buttons to adjust a tempo of your choice.

4)Press and hold the METRONOME button while adjusting the number of beats per measure using the -/NO and +/YES button in the VALUE/SONG section.

+

6. ADVANCED OPERATION

15