EUROGRAND EG2080-RW/BK

The display reads:

04:No stressed beats (default setting)

24, 34, 44, 54, 64, 74: quarter meter (e. g. 2/4)

38, 68, 78, 98, 128: eighth-note meter (e. g. 3/8)

6.4.1 Metronome volume

Use this function to adjust the metronome volume.

Please enter EDIT mode (see chapter 6.1) and select the following function.

Function:E5

Value:1x20

Description:

1x20: Metronome volume (1=low, 20=high)

Proceed as follows for direct access to the metronome volume menu page.

1)Press and hold the METRONOME button, then hit the SELECT button in the TEMPO/EDIT MODE section.

+

The EDIT MODE LED lights up and the EDIT page E5 is displayed.

6.5 Music sequencer

The EG2080 provides a built-in 2-track sequencer which allows you to record and play back a piece of music . For each of the two tracks you can select one or two sounds for recording. This means that the music sequencer can play back up to four sounds at the same time. While playing back a music piece you can also play on the keyboard to produce complex performances with up to six different sounds.

What is more, you can use the music sequencer for practising. For example, you could record the left and right-hand parts of a piece separately on the two tracks. During playback switch off one track (=hand) and play the muted part yourself. Thus, you can practice each part individually within its musical context.

6.5.1 Recording pieces of music

This section describes how to record music pieces with the built-in music sequencer.

1)Press the REC button. The REC LED above the TRACK-1 or TRACK-2 button lights up. The dots in the display start flashing in the adjusted metronome tempo, thus indicating the beat. Now, the EG2080 is set to record mode.

The memory of the music sequencer can store up to 10,000 notes. However, this number can decrease depending on how much pedaling information is stored.

You can quit record mode by pressing the REC button again.

2)If necessary, adjust the metronome tempo and meter as described in chapter 6.4.

3)Keep pressing the TRACK-1 button until the REC LED above the corresponding button lights up red. Now, track 1 is selected for recording. If you did a recording take before, the last track selected will be used for recording. Depending on which track is currently used, you will have to select the other track for recording.

ATTENTION: If the PLAY LED for one of the tracks lights up, this warns you that notes have already been recorded on this track. If you select this track again for recording (REC LED lights up red), the previous recording will be lost.

4)Select a sound in the SOUND SELECT section. You can also use a sound combination (see chapter 5.1) for recording.

5)Switch on the acoustic metronome signal by pressing the METRONOME button, if you want to make a metronome- backed recording.

6)Start recording by pressing the START/STOP button or simply start playing on the keyboard. The current meter is counted in the display.

If the display starts flashing during recording and reads the message FUL, this is to warn you that the recording memory has been used up. All data recorded up to this point will be stored, but the recording process will be terminated.

7)Once your recording is finished stop the sequencer by pressing the START/STOP button again.

16

6. ADVANCED OPERATION