EUROGRAND
Function:E8.4
Value: | On, Off |
Description:
Off: Save function for soft pedal settings is disabled (default setting)
On: Save function for soft pedal settings is enabled
6.6.6 Restoring the factory default settings
Use the following procedure to recall the factory default settings.
ATTENTION: All saved parameters as well as the music sequencer data will be lost during either one of the following procedures.
1)Use the POWER switch to switch the instrument off (if not already done).
2)Play and hold down the top C key on the keyboard, then switch the EG2080 back on.
+
An alternative procedure is described below:
1)Use the POWER switch to switch the instrument off (if not already done).
2)Press and hold down the TRACK 1 and TRACK 2 buttons, then switch the EG2080 back on.
+
3) Let go of the TRACK buttons after about 5 seconds.
7.CONNECTION TO EXTERNAL EQUIPMENT
The EG2080 provides a variety of connectors for connecting the instrument to external devices.
WARNING: Be sure that all devices are switched off before you make any connection.
WARNING: NEVER connect the LINE IN connectors of the EG2080 to its LINE OUT connectors. This will cause a feedback loop producing high volume levels which could damage both the instrument and your hearing!
7.1 Connecting external sound sources
The EG2080 is equipped with a stereo LINE IN connector for connecting external sound sources to your digital piano. These signals are reproduced through the internal loudspeakers and connected headphones. If you wish to practise with musical accompaniment, you can use this input to connect a CD player or drum computer. In the same way, you could connect an external synthesizer or sound module and use its sound generator with your instrument. An additional MIDI connection enables you to play an external sound generator from the keyboard of the EG2080 (see chapter 7.3.1).
The following diagram shows a wiring example comprising the EG2080 and a CD player. You need one or two cables fitted with 1/4" or cinch plugs (see chapter 10.1.3). As an alternative, you can also use a cinch or 1/4" cable with an appropriate adapter plug.
Fig. 7.1: Connecting external signal sources
1)Connect the outputs of the CD player to the LINE IN connectors of the EG2080.
For a mono connection use the LINE IN L (MONO) connector on the EG2080.
7.2Connection to external amplifiers and recording equipment
The EG2080 is equipped with two LINE OUT connectors for connecting the digital piano to external keyboard amplifiers, P.A. systems or home stereo systems. For performances in larger rooms (e.g. stages, hall) it can be necessary to use external amplifiers.
22 | 7. CONNECTION TO EXTERNAL EQUIPMENT |