EUROGRAND EG2080-RW/BK

S2

S3

S1

S2

S4

S1

Fig. 2.2: Assembling the EG2080

This section describes how to assemble the piano step by step.

1)Put the two side panels + on the floor and use the four S1 screws to screw the pedal unit to the two side panels.

2)Route the cable of the pedal unit to the outside (bottom side), so that it is lying loosely on the floor.

3)Stand the frame comprising side panels and pedal unit upright.

4)Put the rear panel , slightly inclined, on the feet of the two side panels, then tilt the upper part of the rear panel towards the metal brackets on the two side panels.

5)Secure the rear panel with four S2 screws (top) to the metal brackets on the side panels, and with the six S3 screws to the pedal unit.

6)Carefully lift the playing console onto the frame. This should be done by two persons. First, place the front side of the playing console – coming from the rear side of the frame

– onto the side panels, then slide the playing console carefully towards the front. If necessary, use your foot to stop the frame from moving forward. Always make sure that the projecting pins on the underside of the playing console are inserted into the guiding rails in the brackets.

7) Secure the playing console to the metal brackets on the side panels from below using the four S4 screws.

2. ASSEMBLY INSTRUCTIONS

7