DENOISER SNR2000
We recommend the following control settings:
Controls | Settings |
IN/OUT switch | IN |
EXPANDER switch | IN |
THRESHOLD control | |
RELEASE control | 2 seconds |
RATIO control | 3:1 |
FILTER switch | IN |
SENSITIVITY switch | |
AUTO switch | IN |
Tab. 3.2: Initial settings of the DENOISER
3.2 Studio applications
3.2.1 Noise reduction during playback
For this standard application, the DENOISER is inserted after the master or multitrack machine, i.e. between tape machine and mixer (or amplifier). A cassette recorder or similar machine may also be the signal source.
Fig. 3.1: Noise reduction during playback
1.Set up your equipment as usual, while bypassing your DENOISER.
2.Turn on the BEHRINGER DENOISER and adjust the controls as desired (if necessary, read chapter 1.3 “Control elements” once again).
3.Check your settings by making A/B comparisons using each channel’s IN/OUT switch.
3.2.2 Noise reduction during recording
The noise reduction effect may be increased by using the DENOISER not only during playback but also when recording. For this purpose, insert the unit directly after the master output of the mixer into the recording path of the master or multitrack machine. Set up the unit as described in the previous section “Noise reduction during playback”.
In particularly difficult cases, we recommend using the DENOISER both during recording and playback.
16 | 3. APPLICATIONS |
