Beko AP930 manual Water Filter

Models: AP930

1 21
Download 21 pages 61.03 Kb
Page 7
Image 7
Water Filter

Water Filter

Bypass Cover

Water Tubes

Bypass Cover

Water Tubes

Filter

Water filter should be replaced every 6 months. Water filter warning on the display will come on after about 6 months. The warning light remain on for about 15 days before it starts to flash. Once the filter has been replaced, this warning light can be cancelled by pressing the “Auto Eco” button on the display for 5 seconds.

The water filter must be removed as shown in the figure when it is going to be replaced or when it will no longer be used. Make sure that the “Ice off” mode is active before removing the water filter.

To fit the water filter follow the instructions below referring to diagrams supplied:

1.Take out the upper salad crisper in the fridge as shown in the figure.

2.Unscrew the water filter by-pass cover.

Warning: Make sure that the “ice off” mode is active before taking out the by-pass cover.

Note: It is normal for a few drops of water to drip after the cover has been removed.

3.Remove the red cap on the top of the water filter cartridge and fix it to its place as shown in the figure.

4.Press “Ice off” button on the display again to exit from this mode.

If you do not want to use the water filter, warning light should be cancelled. To do this, “Freezer Set” and “Water/Ice Selection” buttons must be pressed simultaneously for 2 seconds. Filter warning will flash for 5 times when pressed in this way and the warning will be cancelled. Filter warning will flash for 10 times when the same buttons are pressed for 2 seconds and the warning will be reactivated.

Warning: Water filter is for cleaning some foreign particles in the water. It does not purify water from micro-organisms.

Warning: “Ice off” button must always be pressed while replacing the water filter or installing the bypass cover.

Water Reservoir

1

2

3

If you wish to disassemble the water reservoir from the refrigerator for cleaning purposes follow the below instructions;

• Remove the 2 screws by using a cross headed Manual background screwdriver as shown in the figure. Manual backgroundManual backgroundManual backgroundManual background

• Gently hold and remove the water reservoir Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background shown in the figure.Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background

Warning:

Never remove the nuts fitted to the water reservoir after cleaning the area behind the water reservoir, gently refit and check that there is no water leak. If you over tighten the nuts, it may cause leakage.

Water Reservoir (Capacity is 0.9 L)

10

11

Page 7
Image 7
Beko AP930 manual Water Filter