Using two-in-one detergent and rinse aid
•These detergents will not give you the same drying performance that you can obtain by using separate detergent, salt and rinse aid. To increase the drying performance:
•Put your appliance’s rinse aid setting at “1” and apply rinse aid. When the rinse aid is used up, add more rinse aid to the rinse aid dispenser.
•If you use combined detergents with a rinse aid setting higher than 1, hand contact may leave
•These detergents do not contain softening salt so you need to use the softening setting as described in the manual, making sure that there is salt in the water softener with every wash and that you refill the water softener with salt every time it is empty.
Important warning
Should you encounter a problem that has previously never occured after you start using these detergents, contact the detergent manufacturer directly. You will find contact details on the packet.
If you stop using this kind of detergent:
•Ensure that the salt and rinse aid dispensers are full.
•Put the water hardness setting at the highest level and run a wash cycle with the appliance empty.
•After washing while empty, return the water hardness setting to the correct level for your mains water
15
hardness shown in the manual.
•Put the rinse aid setting at the correct level.
Filling detergent dispenser
If the dishwasher is considerably full and the dishes are relatively dirty, fill the main container (A) up to 25cm³ level. If the dishwasher is not quite full and the dishes are only slightly soiled, fill the main container (A) only up to 15cm³ level.
If your dishes are kept unwashed for a long time and the food particles are stuck on the dishes also fill the small container (B) up to 5cm³. Depending on the degree of soiling and the water hardness in your area it may be necessary to add more detergent.
Powder and gel detergents are poured into the dispenser.
If you are using tablet detergent read the manufacturer’s recommendations on the packaging in order to determine
GB
