Preparations for the Remote Control

Insert the batteries into the remote control, and you can use it to operate DVD player.

Operating with the Remote Control

This section shows you how to use the remote control.

1

Open the cover

Point the remote control at the remote sensor and press the buttons.

2

Insert batteries

 

Angle: About 30°in each direction of the remote sensor.

3

-

+

+

-

Make sure to match the + and - to the mark inside the battery compartment.

Close the cover.

Do not expose the remote sensor of the DVD player to a strong light source such as direct sunlight or illumination. If you do so, you may not be able to operate the DVD player with the remote control.

Notes on Batteries

Improper use of batteries may cause battery leakage and corrosion. To operate the remote control correctly, follow the instructions below.

Do not insert the batteries into the remote control in the wrong direction.

Do not leave the discarded or exhausted batteries in the remote control.

Do not use different types of batteries together, or mix old and new batteries.

Notes on the Remote Control

Direct the remote control at the remote sensor of the DVD player.

Do not drop or give the remote control a shock. Do not leave the remote control near an extremely hot or humid place.

Do not spill water or put anything wet on the remote control.

Do not open the remote control.

If you do not use the remote control for a long period of time, remove the batteries to avoid possible damage from battery corrosion.

If the remote control does not function correctly or if the operating range becomes reduced, replace all batteries with new ones.

If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new batteries.

The battery can last for about 1 year when normally used.

9

Page 11
Image 11
Beko DVD 2008 manual Preparations for the Remote Control