Troubleshooting
•The Setup Assistant completed installation, but my web browser doesn’t work.
•I am unable to connect to the Internet. The “modem” LED on my Router is off, and the “internet” LED is blinking.
If you cannot connect to the Internet, and the “modem” LED is off, and the “internet” LED is blinking, the problem may be that your modem and Router are not connected properly.
1.Make sure the network cable between the modem and the Router is connected. The cable should be connected at one end to the Router’s “to Modem” port, and at the other end to the network port on your modem.
2.Unplug the cable or DSL modem from its power source for
three minutes. After three minutes, plug the modem back into its power source. This may force the modem to properly recognize the Router.
3.Unplug the power to your Router, wait 10 seconds, and then reconnect the power. This will cause the Router to reattempt communication with the modem. If the “modem” LED on the Router is not lit after completing these steps, please contact Belkin Technical Support.
4.Try shutting down and restarting your computer.
83
