Belshaw Brothers and 734CG, 724CG, 718LCG manual Washing

WARNING

Do not allow the shortening to overflow the

containers. Shortening will get on the floor, and if the shortening is not cool enough, you may be burned.

2.Connect the fryer to the power source. Move the on/off switch to ON. Set the temperature control to 200°F/93°C. Keep the cleaning solution at this temperature for 15-20 minutes.

3.Scrub the soiled parts while the solution is hot. Do not use any abrasive cleaners or scrapers.

WARNING

Thoroughly clean and dry the floor if shortening is spilled. Shortening on the floor can cause serious injury or loss of life.

6.Using a non-abrasive, non-metallic spatula, scrape the sediment and any remaining shortening into the drain valve.

WARNING

To avoid fire, serious injury, and

equipment damage, do not attempt to burn

carbon off of the heat tubes.

7.Close the drain valve.

8.If your fryer has a Belshaw Shortening Melter (FM) connected to it, install the plug into the reservoir nipple.

Washing

1.Pour hot water into the kettle, up to the normal level of the shortening. Add trisodium phosphate or another appropriate cleaner.

CAUTION

To avoid severe damage to the kettle, never turn on the heat unless the heat tubes are completely covered by liquid.

WARNING

To avoid being burned, be very careful as you work with hot cleaning solution. Never put your hands in the solution. Wear gloves and long sleeves in case any solution splashes.

4.Move the on/off switch to OFF and disconnect the fryer from the power source. Allow the cleaning solution to cool to 100°F/38°C.

5.Place a large metal container under the drain valve.

WARNING

Do not use plastic containers. If the cleaning solution is not cool enough, the containers will melt; possibly causing you to be burned, and causing cleaning solution to get on the floor.

6.Open the drain valve and allow the cleaning solution to drain into the container.

7.Watch the container to make sure the cleaning solution does not overflow. If the container becomes full, close the drain valve, put another large metal container under the drain valve, and open the drain valve again.

Belshaw Bros., Inc. • 1750 22nd Ave. S. • Seattle, WA 98144 • Phone 206-322-5474 • Fax 206-322-5425

718LCG, 724CG, and 734CG Gas Fryers MN-1141EN 9