Belshaw Brothers EZ18, EZ24, EZ34 manual Turn the pump on using the PUMP switch

5.Make sure that the HEAT and PUMP switches are in the OFF position. Connect the EZ Melt to the power source.

To avoid damaging the heating element, make sure it is completely covered with shortening before you turn the heater on.

6.Turn the machine on using the HEAT switch. When the heat is on, the heating element melts shortening at 200“ F/93“ C. The heat must also be on to operate the pump.

7.Turn the pump on using the PUMP switch.

8.When you want to supply shortening to the fryer, press the foot pedal.

WARNING

To avoid burning yourself, never touch the

nozzle while the machine is in use.

9.When the fryer has enough shortening in it, release the foot pedal.

10.As needed, add shortening to the kettle, one cube at a time. Always add a cube if the shortening level drops to the tops of the legs of the cube melter. (See Figure 2-4 & 2-4A.)

	SIDE OF	IF
		SHORTENING
	CUBE
		LEVEL IS
	MELTER
		HERE OR
		BELOW ADD
		ONE CUBE OF
		SHORTENING
BOTTOM OF
KETTLE

Figure 2-4. When to Add a Cube of

Shortening.

SIDE OF	IF	SHORTENING
CUBE	LEVEL IS HERE
MELTER	OR BELOW ADD
	ONE CUBE OF
	SHORTENING.
BOTTOM OF
KETTLE

Figure 2-4A. (EZ34 ONLY) When to Add a

Cube of Shortening.

To add a cube of shortening, follow these steps:

1.Position the filter assembly so you can add shortening. The edge of the kettle has one or two sets of holes in it. Use the set of holes that is nearer to the heater head. When two of the filter frame’s pins rest in these holes, the filter assembly hangs vertically. (See Figure 2-5.)

Figure 2-5. Positioning the Filter Frame for

Melting.

b.Place a solid cube of shortening on the cube melter. Let one cube melt and be pumped out before adding another cube. Do not overload the EZ Melt.

Belshaw Bros., Inc. š 1750 22nd Ave. S. š Seattle, WA 98144 š Phone 206-322-5474 š Fax 206-322- 5425

6 MN-1316EN EZ Melt Model EZ18, EZ24, EZ34