Adjusting the Audio Level
Once your unit has completed the
To reverse the direction in which the audio level increases/ decreases, briefly release, then hold down the ⁄ button again.
(Dim/Dark) Button
The button allows selection of a dim or dark setting for all leds and the Digital Display. To engage dim mode, press the drk button once. A single “beep” confirms your selection. To completely cancel the illumination of all leds, press drk a second time. You’ll notice a horizontal bar segment remains dim to indicate your unit is receiving power. To return to a full bright setting, press the drk button a third time; two “beeps” confirm this selection. Use of the drk button does not affect audio alerts.
(Audio Mute) Button
Continuous Audio Alert Pattern
Your unit has been preset at the factory to provide an X, K, Ka or Laser audio alert and Digital Voice announcement of the signal detected. Digital Voice prompts are provided once after the initial audio alert. This standard setting is often preferred when background noise in a vehicle is loud.
Automatic Mute Audio Alert Pattern (Radar)
| To engage automatic muting, press the button once when | |
| the unit is not alarming. A single “beep” and a decimal point in | |
| the upper left corner of the Digital Display confirm automatic | |
| mute mode has been engaged. The alert pattern when this mode | |
| is activated consists of a short X, K or Super Wideband Ka | |
| audio alert followed by the Digital Voice announcement of the | |
| signal detected (if feature is engaged). After the Digital Voice | |
| announcement, a “clicking” tone keeps you quietly informed | |
| ||
for as long as the signal is present. This “clicking” becomes | ||
| ||
|
|
