Using the menus, Picture menu, Keystone | BenQ MP620p guide

Using the menus

The projector is equipped with on-screen display (OSD) menus for making various adjustments and settings.

There are 17 different menu languages. (Refer to page "4. Advance menu" on page 33 for more details.)

The following example describes the adjustment of the keystone.

1. Press 6Menu on the projector or Menu 4.			Adjust keystone values by
on the remote control to turn the on-			pressing Left 3/ Right 4on the
screen menu on.			projector or Left 3/ Right 4on
			the remote control.
			the remote control.

2.	Use 3Left/ Right 4on the projector or			5.	Press5Exit on the projector or
	Left 3/ Right 4on the remote control				press Menu twice* on the
	to select the		Picture menu.		remote control to leave and save

					the setting.

3.	Press 5Exit or 6Menu on the projector			*The first press leads you back to the
	or 6/ 5on the remote control to select
				submenu and the second press closes

	Keystone.	the on-screen menu.
	Keystone.

28 Operation

Image 34

BenQ MP620p user manual Using the menus, Picture menu, Keystone

Contents

Welcome Copyright Disclaimer Table of contents Iv Table of contents Supported timing for Component-YPbPr input Table of contents Regulation Statements Memo Vi Table of contents But could fail if power cuts or surges Important safety instructionsRefer servicing to qualified service personnel Important safety instructions Safety Instructions Bedding or any other soft surface Safety Instructions Introduction Projector featuresIntroduction Shipping contents Rear side Projector exterior viewFront / upper side Lower side Mation Controls and functionsExternal control panel Turns the projector on or off Freeze Remote controlAdjusts the focus of the projected image 5Up, 6 Down 3Left, Right4 Pull out the battery holder Remote control effective rangeReplacing the remote control battery Push the holder into the remote control Positioning your projector Choosing a location Obtaining a preferred projected image size Positioning your projector 1219 Maximum zoom Minimum zoomScreen Center of lens Projection distance 1500 Connecting a computer Connecting a computer or monitorConnection Connecting a monitor Connecting Video source devices Best video quality Connecting a Component Video source device 1080i 50/ 60 Hz Connecting an S-Video source device Device Video cable Audio cables Connecting a composite Video source device Operation Utilizing the password functionTo set a password Start up To change the password If you forget the passwordTo enter the password recall procedure Password set-up and return to the on-screen menu Auto-adjusting the image Adjusting the heightFine-tuning the image size and clarity Correcting keystone For example Switching input signal Selecting an application modeHiding the image Remote paging operations Power indicator light flashesDisconnect the power cord from the wall socket Freezing the image Menu operation Menu system Picture menu Using the menusKeystone Picture menu Selected Color TempDepends on Brightness Pro-Picture menu Setting menu Advance menu Auto Off off Mode offHigh Altitude Economic Information menu ResolutionMode Equivalent Source Maintenance Care of the projector Calculation of lamp hour Lamp informationMessage Status Replacing the lamp Page Tighten the screw that secures the lamp Temperature informationResetting the lamp counter Restart the projector Light Status & Description Power Temp Lamp Lamp events IndicatorsLight Status & Description Power Temp Lamp Power events Projector is under normal operation Light Status & Description Power Temp Lamp Thermal events For assistance Maintenance Make sure that it is switched on TroubleshootingPlug the power cord into the AC inlet on Cause Remedy Specifications Projector specifications Supported timing for Component-YPbPrinput Timing chartSupported timing for PC input Supported timing for Video and S-Video inputs Dimensions Unit mm Specifications Limited Warranty WarrantyWarranty EEC statement Regulation StatementsFCC statement MIC statement