Operation
Start up
1.Plug the power cord into the projector and into a wall socket. Turn on the wall socket switch (where fitted).
Check that the Power indicator on the projector lights orange after power has been applied.
2.Remove the lens cap. If it is left on, it could become deformed due to heat.
3.Press and hold (for 2 seconds) the Power
button on the remote control or projector to start the unit. The Power indicator light flashes green and stays green when the unit is on. The start up procedure takes about 30 seconds after pressing Power. In the later stage of start up, a default BenQ logo is projected.
4.If you are prompted for a password, press the arrow buttons to select the four password digits, then press Auto. For information about
the password function, refer to "Utilizing the password function" on page 21.
5.Switch all of the connected equipment on.
6.The projector will start to search for input signals. The current input source being scanned displays at the center of the screen. The search will continue until an input source signal is detected.
You can also press Source on the projector or remote control to select your desired input signal. For more information, please refer to "Switching input signal" on page 25.
If the frequency/ resolution of the input signal exceeds the projector’s operating range, you will see the message “Out of Range” displayed on a blank screen.
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an option for setting up password security. The password can be set through the
WARNING: You will be inconvenienced if you activate the password functionality and subsequently forget the password. Print out this manual (if necessary) and write the password you used in this manual, and keep the manual in a safe place for later recall.
To set a password
CAUTION: Once a password has been set, the projector cannot be used unless the correct password is entered every time the projector is started.
1.Open the 
Setting > Password. Select On by pressing Left 3or Right4.
Operation 21
