BenQ MP622c, MP612c user manual Connecting a Component Video source device

Connecting a Component Video source device

Examine your Video source device to determine if it has a set of unused Component Video output sockets available:

•If so, you can continue with this procedure.

•If not, you will need to reassess which method you can use to connect to the device.

To connect the projector to a Component Video source device:

1.Take a Component Video to VGA (D-Sub) adaptor cable and connect the end with 3 RCA type connectors to the Component Video output sockets of the Video source device. Match the color of the plugs to the color of the sockets; green to green, blue to blue; and red to red.

2.Connect the other end of the Component Video to VGA (D-Sub) adaptor cable (with a D-Sub type connector) to the D-SUB/COMP IN socket on the projector.

3.If you wish to make use of the projector (mixed mono) speaker, take a suitable audio

cable and connect one end of the cable to the audio output socket of the computer, and the other end to the Audio socket of the projector.

The final connection path should be like that shown in the following diagram:

A/V device

Audio cables

Component Video to VGA (D-Sub) adaptor cable

If you connect the projector to a High Definition TV (HDTV) tuner, the following standards are supported:

•	480i	•	480p
•	576i	•	576p
•	720p (50/ 60 Hz)	•	1080i (50/ 60 Hz)

• The projector is only capable of playing mixed mono audio, even if a stereo audio input is connected. See "Connecting Audio" on page 22 for details.

•Component Video is the only video output that delivers native 16:9 aspect ratio picture.

•If the selected video image is not displayed after the projector is turned on and the correct video source has been selected, check that the Video source device is turned on and operating correctly. Also check that the signal cables have been connected correctly.

Connection 23