BenQ MP723 Setting a password, If you forget the password, to the Security Settings page

Setting a password

Once a password has been set and the power on lock is activated, the projector cannot be used unless the correct password is entered every time the projector is started.

Once a password has been set and the splash screen lock is activated, you cannot change the splash screen that displays at projector startup unless the correct password is entered.

1.Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security Settings menu. Press Mode/enter on the projector or ENTER on the remote control. The Security Settings page displays.

2.Highlight Change Security Settings and press Mode/enter on the projector or ENTER on the remote control.

3.	As pictured to the right, the four arrow buttons		INPUT NEW PASSWORD
	( ,	, , ) respectively represent 4 digits (1,	Power On Lock and Splash Screen Lock
			use the same password
	2, 3, 4). According to the password you desire to
	set, press the arrow buttons to enter six digits for
	the password.
4.	Confirm the new password by re-entering the
	new password.

Once the password is set, the OSD menu returns

to the Security Settings page.

MENU Back

5.To activate the Power On Lock function, press / to highlight Power On Lock and press / to select On.

6.To activate the Splash Screen Lock function, press / to highlight Splash Screen Lock and press / to select On.

When the Splash Screen Lock is activated, the My Screen function in the SYSTEM SETUP: Basic menu will be password-protected.

IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password down here in this manual in advance or right after the password is entered so that it is available to you should you ever forget it.

Password: __ __ __ __ __ __

Keep this manual in a safe place.

7.To leave the OSD menu, press MENU/EXIT.

If you forget the password

If the password function is activated, you will be asked to enter the six digit password every time you turn on the projector. If you enter the wrong password, the password error message as pictured to the right displays lasting for three seconds, and the INPUT PASSWORD message follows. You can retry by entering another six- digit password, or if you did not record the password in this manual, and you absolutely do not remember it, you can use the password recall procedure. See "Entering the password recall procedure" on page 30 for details.

If you enter an incorrect password 5 times in succession, the projector will automatically shut down in a short time.

Password Error

Please try again.

Operation 29