Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer. See "Indicators" on page 59 for details.
The following Lamp warning displays will remind you to change the lamp.
Status | Message | |
The lamp has been in operation for 3000 hours. | Notice | |
Install a new lamp for optimal performance. If the | ||
| ||
projector is normally run with "Economic Mode" | Order Replacement Lamp | |
selected (See "Lamp Mode (Normal)" on page 51), | ||
| ||
you may continue to operate the projector until | Lamp > 3000 Hours | |
the 3950 hour lamp warning appears. |
| |
| OK | |
|
| |
The lamp has been in operation for 3950 hours. A | Notice | |
new lamp should be fitted to avoid the | ||
| ||
inconvenience when the projector runs out of | Replace Lamp Soon | |
lamp time. | ||
| ||
| Lamp > 3950 Hours | |
| OK | |
|
| |
The lamp has been in operation for 4000 hours. | Notice | |
| ||
It is strongly recommended that you replace the | Replace Lamp Now | |
lamp at this age. The lamp is a consumable item. | ||
The lamp brightness diminishes with use. This is | Lamp > 4000 Hours | |
normal lamp behavior. You can replace the lamp | ||
Lamp usage time exceeded | ||
whenever you notice that the brightness level has |
| |
significantly diminished. If the lamp is not | OK | |
replaced beforehand, it must be replaced after | ||
| ||
3000 hours usage. |
| |
|
| |
The lamp MUST be replaced before the projector | Notice | |
will operate normally. | ||
| ||
| ||
| Replace lamp (refer to User manual) | |
| Then reset lamp timer | |
| OK | |
|
|
Maintenance 55
