BenQ MP723 user manual Operating in a high altitude environment, Creating your own startup screen

Operating in a high altitude environment

We recommend you use the High Altitude Mode when your environment is between 1500 m –3000 m above sea level, and temperature is between 0°C–35°C.

Do not use the High Altitude Mode if your altitude is between 0 m and 1500 m and temperature is between 0°C and 35°C. The projector will be over cooled, if you turn the mode on under such condition.

To activate the High Altitude Mode, go to the SYSTEM

SETUP: Advanced > High Altitude Mode, select On

by pressing / on the projector or remote control. A confirmation message displays. Highlight Yes and press Mode/enter on the projector or ENTER on the remote control.

WARNING

We recommend you use the High Altitude Mode by selecting it whenever your environment is higher than 1500 m.

Do you want to turn High Altitude Mode on?

Yes No

Operation under "High Altitude Mode" may cause a higher decibel operating noise level because of

increased fan speed necessary to improve overall system cooling and performance.

If you use this projector under other extreme conditions excluding the above, it may display auto shut-down symptoms, which is designed to protect your projector from over-heating. In cases like this, you should switch to High Altitude mode to solve these symptoms.

However, this is not to state that this projector can operate under any and all harsh or extreme conditions.

Creating your own startup screen

In addition to selecting the projector preset startup screen from among BenQ logo, Black or Blue screen, you can make your own startup screen that is a picture projected from your computer or video source.

To create your own startup screen, project the picture you want to use as your startup screen from either a computer or video source. The rest steps are as follows.

•Using the remote control

1.Press CAPTURE on the remote control.

2. A confirmation message displays. Press CAPTURE or ENTER again.

3. The message 'Screen Capturing...' displays while the projector is processing the picture. Please wait.

4. If the action is successful, you see the message 'Captured Succeeded' on the screen. The captured picture is saved as My Screen.

5.To view the captured picture displayed as the startup screen, set My Screen in the SYSTEM SETUP: Basic > Splash Screen menu and restart the projector.

•Using the OSD menu

1.Press MENU/EXIT and then press / until the SYSTEM SETUP: Basic menu is highlighted.

2.Press to highlight My Screen and press Mode/enter.

3.Repeat steps 2-5in the “Using the remote control” section to capture and view the captured picture.

In the unlikely event that the capturing action fails, change your target picture.

Operation 43