Personalizing the projector menu display
The
•Menu display time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the length of time the OSD will remain active after your last key press. The time
length ranges from 5 to 30 seconds in 
/ 
to select a suitable time frame.
•Menu position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD position in five locations. Use 
/ 
to select a preferred position.
•Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD menus. Use 
/ 
to select your language.
•Reminder Message in the SYSTEM SETUP: Advanced > Menu Settings menu
sets whether to display reminder messages on screen. Use 
/ 
to select your desired setting.
•Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed during projector 
/ 
to select a screen.
Select the lamp saver mode
•Using the remote control.
Press Smart Eco and Highlight Lamp mode and press 
/ 
to select Normal/ Economic/Smart Eco.
•Using the OSD menu.
1.Press Menu/Exit and then press 
/ 
until the SYSTEM SETUP: Advanced menu is highlighted.
2. Press 
to highlight Lamp mode and press
Mode/Enter. The Lamp Settings page displays.
3.Highlight Lamp mode and press 
/ 
to select Normal/Economic/Smart Eco. The lamp brightness vary from the different lamp mode,see the description list
in table below.
Lamp mode | Description | |
Normal | 100% lamp brightness. | |
|
| |
Economic | 80% lamp power consumption. | |
|
| |
Smart Eco | This is default setting. Lamp power consumption will save from 30% to | |
100% dynamically by detecting the content brightness level. | ||
| ||
|
|
If the Economic mode is selected, the light output will be reduced and result in darker projected pictures.
Operation 45
