the password recall procedure. See "Entering the password recall procedure" on page 23 for details.
If you enter an incorrect password 5 times in succession, the projector will automatically shut down in a short time.
Entering the password recall procedure
1.Press and hold AUTO on the projector or remote control for 3 seconds. The projector will display a coded number on the screen.
2.Write down the number and turn off your projector.
3.Seek help from the local BenQ service center to decode the number. You may be required to provide proof of purchase documentation to verify that you are an authorized user of the projector.
RECALL PASSWORD
Please write down the recall code, and contact BenQ
Customer Center.
Recall Code:
255 255 255 255
MENU Exit
Changing the password
1.Open the OSD menu and go to the SYSTEM SETUP: Advanced> Security Settings > Change Password menu.
2.Press MODE/ENTER. The message “INPUT CURRENT PASSWORD” appears.
3.Enter the old password.
i.If the password is correct, another message “INPUT NEW PASSWORD” appears.
ii.If the password is incorrect, the password error message appears lasting for three seconds, and the message “INPUT CURRENT PASSWORD” appears for your retry. You can press MENU/EXIT to cancel the change or try another password.
4.Enter a new password.
IMPORTANT: The digits being input will display as asterisks
Password: __ __ __ __ __ __
Keep this manual in a safe place.
5.Confirm the new password by
6.You have successfully assigned a new password to the projector. Remember to enter the new password next time the projector is started.
7.To leave the OSD menu, press MENU/EXIT.
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced > Security Settings > Change Security Settings menu after opening the OSD menu system. Press MODE/ENTER. The message “INPUT PASSWORD” appears. Enter the current password.
i.If the password is correct, the OSD menu returns to the Security Settings page.
Operation 23
