Current, System, Status | BenQ MX662 instruction

Function

6.
INFORMATIONmenu	Current
	Current
	System
	Status

Description

Source

Shows the current signal source.

Picture Mode

Shows the selected mode in the PICTURE menu.

Resolution

Shows the native resolution of the input signal.

Lamp Mode

Shows the current lamp mode.

3D Format

Shows the current 3D mode.

Color System

Shows input system format: NTSC, PAL, SECAM, YUV, or RGB.

Equivalent Lamp

Displays the number of hours the lamp has been used.

Firmware Version

Shows the firmware version of your projector.

46 Operation

Page 46

Image 46

BenQ MX662 user manual Current, System, Status

Contents

MX662/MW663 Digital Projector Table of contents Important safety instructions Safety Instructions Safety Instructions 3000 m Feet Ceiling mounting the projector Projector features Introduction Shipping contents Front/upper side Projector exterior viewRear/lower side Controls and functions Remote control Remote control effective range Replacing the remote control batteries Front Table Positioning your projectorChoosing a location Front Ceiling MX662 Projection dimensionsObtaining a preferred projected image size Max length Offset Inch MW663 Connection Connection Terminal name Terminal appearance Connecting video source devicesConnecting audio Best Operation Starting up the projector Auto-adjusting the image Adjusting the projected imageAdjusting the projection angle Fine-tuning the image size and clarity Correcting keystone Using the menus Below is the overview of the OSD menu Setting a password Using a security cable lockUtilizing the password function If you forget the password Changing the password Entering the password recall procedureDisabling the password function Switching input signal Changing Color Space Magnifying and searching for details Selecting the aspect ratio About the aspect ratio MX662 MW663 Setting the User 1/User 2 mode Using Wall ColorSelecting a picture mode Go to the Picture Picture Mode menu Adjusting Brilliant Color Fine-tuning the image quality in user modesSelecting a Color Temperature Setting a preferred color temperature 3D Color Management Resetting current or all picture modes Setting the presentation timerSelection Description Freezing the image To cancel the timer, perform the following stepsRemote paging operations Top-Left Bottom-Left Top-Right Bottom-Right Locking control keys To activate the High Altitude ModeHiding the image Operating in a high altitude environment Adjusting the sound level Adjusting the soundUsing the test pattern Turning off the Power On/Off Ring Tone Using the teaching templates To select Blackboard or Whiteboard Presenting from a USB Reader Direct power off Shutting down the projector Menu system Menu operationMain menu Sub-menu Options Basic Advanced Description of each menu Color Temperature Picture ModeTemperature Fine Tuning 3D Color Settings TimerInstallation Search Remote System Setup Basic menu Function DescriptionOperation Receiver Audio System Setup Advanced menu Function Description HighAltitude Lamp Standby System Setup Advanced menu Function DescriptionReset All Network System CurrentStatus Maintenance Care of the projector Getting to know the lamp hour Lamp informationExtending lamp life Timing of replacing the lamp Status Message Replacing the lamp Resetting the lamp timer Use the handle to slowly pull the lamp out of the projector Maintenance Lamp events IndicatorsLight Status & Description Power events Thermal events Troubleshooting Specifications Projector specifications Dimensions Ceiling mount installation Timing chart Supported timing for PC input Supported timing for Hdmi Hdcp input KHz Pixel Supported timing for Component-YP bP r inputSupported timing for Video and S-Video inputs Timing Copyright Warranty and Copyright informationLimited warranty Disclaimer