G.OPERATING INSTRUCTIONS:

ENGINE START

1.Connect the battery charger to the vehicle according to section E (CHARGING BATTERY IN VEHICLE) found earlier in this manual.

2.Performance will be enhanced if you charge the battery for 5-10 minutes in the 12v 15 amp position before attempting to start.

3.Set the charge rate selector switch to the 110 amp start position.

4.Crank the engine for 2-4 seconds.

5.If the engine fails to start, charge the battery in the 12v 15 amp position for another 5-15 minutes and then attempt to start the engine again.

6.If the engine fails to start after several attempts, there may be a problem elsewhere with the vehicle.

7.When disconnecting, always disconnect power cord first, then remove clip from vehicle chassis, and finally remove the clip from the battery terminal.

H.CHARGE PERIOD

The approximate time required to bring a battery to a full charge state depends upon the number of ampere hours (AH’s) de- pleted from the battery. AH’s are determined by multiplying the number of hours times the number of amps supplied by a bat- tery to a load. For example - if a load was connected to a battery which drew 10 Amps for a period of 5 hours, the battery will have supplied 50 AH’s. The approximate recharge time required to restore the 50 AH’s depleted from the battery would be calcu- lated by dividing 50 AH’s by the selected charge rate. If the 15 Amp charge rate is chosen then divide 50 AH’s by 15 Amps, this equal to 3.3 hours or 3 hour and 20 minutes. During the charge cycle, the 15 Amp charge rate will not remain constant, rather as the battery charges it will taper to approximately 6-7 Amps. Also not all of the energy going into the battery is directly con- verted, some is lost in the form of heat. For these reasons allow an additional 25% in charge time. For this example add 50 min- utes to the 3 hour and 20 minutes for a total recharge time of 4 hour and 10 minutes.

50 = 3 Hours 20 Minutes

15

3 Hours (180 minutes + 20 minutes = 200 minutes) 200 x 1.25 = 250 minutes or 4 Hours & 10 minutes

TROUBLESHOOTING

If a problem does occur, check the following:

PROBLEM

POSSIBLE CAUSE

SOLUTION

 

 

 

No meter reading.

Clips are not making

Rock clips back and forth

 

a good connection

for a better connection.

 

AC Cord unplugged.

Plug AC line into outlet.

 

 

Meter should now indicate.

 

 

 

Charger will not

AC outlet is dead.

Plug in a lamp to check for

turn on when

 

voltage.

properlyconnected.

 

 

 

Poor electrical

Check connectors, rock

 

connection.

back and forth for a better

 

 

connection.

 

 

 

Clicking noise from

Circuit breaker is

May be in the wrong switch

charger.

cycling.

position.

 

Battery is defective.

Have Battery checked.

 

Severely discharged

Allow charging to continue

 

battery but otherwise

until battery has a chance

 

a good battery.

to recover sufficiently to take

 

 

a charge. If more than 20

 

 

minutes stop charging and

 

 

have the battery checked.

 

Reverse connections

Shut off charger and correct

 

at battery.

lead connections.

 

 

 

LIMITED WARRANTY

SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CEN- TER DRIVE, MOUNT PROSPECT, ILLINOIS 60056-2179 MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE.

Schumacher Electric Corporation warrants this battery charger for two years from date of purchase at retail against defective material or work- manship. If such should occur, the unit will be repaired or replaced at the option of the manufacturer. It is the obligation of the purchaser to forward the unit together with proof of purchase, transportation and/or mailing charges prepaid to the manufacturer or its authorized repre- sentative.

This limited warranty is void if the product is misused, subjected to careless handling, or repaired by anyone other than the manufacturer or its authorized representative.

The manufacturer makes no warranty other than this limited warranty and expressly excludes any implied warranty including any warranty for consequential damages.

THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES ANY- ONE TO ASSUME OR MAKE ANY OTHER OBLIGATION TO- WARDS THE PRODUCT OTHER THAN THIS EXPRESS LIMITED WARRANTY. THE MANUFACTURER MAKES NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE OF THIS PRODUCT AND EXPRESSLY EXCLUDES SUCH FROM THIS LIM- ITED WARRANTY.

SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITA- TION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES OR LENGTH OF IMPLIED WARRANTY SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

5

Page 5
Image 5
Schumacher SE-2150MA Operating Instructions Engine Start, Charge Period, Troubleshooting, Problem Possible Cause Solution

SE-2150MA specifications

The Schumacher SE-2150MA is a highly versatile and efficient battery charger and maintainer designed for a variety of automotive applications. This compact and powerful device is particularly popular among car enthusiasts and those who require a reliable solution for recharging and maintaining lead-acid batteries, including conventional, AGM, and gel types.

One of the standout features of the Schumacher SE-2150MA is its automatic multi-stage charging technology. This advanced system ensures that the battery is charged quickly and efficiently while minimizing the risk of overcharging. The multi-stage process involves bulk charging, absorption, and float modes, which together promote optimal battery health and longevity. The device is equipped with an intelligent microprocessor that monitors and adjusts the charging process in real-time, providing precise and safe charging for both 12V and 6V batteries.

The SE-2150MA also boasts a built-in LCD display that clearly shows the charge status, voltage, and other relevant information at a glance. This feature enhances user experience, enabling users to keep track of the charging process without having to guess or rely on indicators alone. Additionally, the device is designed with safety in mind; it includes protection against reverse polarity, short circuits, and overheating, ensuring safe operation even for those who may be less experienced with battery maintenance.

Another notable aspect of the Schumacher SE-2150MA is its compact and lightweight design, making it easy to store and transport. This aspect is particularly appreciated by users who need a portable solution that can easily be taken from one vehicle to another or stored in a tight space when not in use.

Furthermore, the SE-2150MA features alligator clips and ring terminals, providing versatility in connection options. This allows users to connect the charger to various types of batteries easily and securely. The long cables enhance maneuverability, making it convenient to reach difficult areas within the engine compartment.

Overall, the Schumacher SE-2150MA combines user-friendly operation, advanced technology, and robust design to deliver a reliable battery charging solution for automotive enthusiasts and everyday drivers alike. Whether for seasonal maintenance or regular use, this charger offers an effective way to keep batteries in peak condition, reflecting Schumacher’s legacy of quality and innovation in automotive care products.