3.RGB&COMPONENT: The following settings are only available with a PC or Digital Television RGB signal:
■AUTO: Adjusts the phase, frequency and position automatically.
■FREQ.: Adjusts the frequency of the sampling clock that captures the input signal.
■PHASE: Adjusts the phase of the clock.
■H. POS.: Adjusts the horizontal position of the image.
■V. POS.: Adjusts the vertical position of the image.
The available adjustment range of the vertical position depends on the type of the input signal that is being displayed. The vertical position cannot be changed with some types of signal.
4.SAVE: There are three video memories in which users can store settings, including all items in the Picture and
Input source | Number of available memories |
|
|
VIDEO | 3 |
3 | |
COMPONENT 1, 2 | 3 |
3 | |
|
|
■To store the settings:
i.) Adjusts the items in the Picture and
ii.) Go to the Display menu and select SAVE, press Enter. The SAVE OSD will be shown as the picture above.
iii.) Select MEMORY 1, MEMORY 2 or MEMORY 3 and press ENTER to sore the settings. iv.) To leave the OSD, press MENU.
5.LOAD: Loads the settings from one of three video memories.
ENVIRONMENT Menu
In this menu, global settings for the projector can be made.
There are four items available: DEFAULT — LAMP TIMER — AUTO OFF — LAMP HOURS.
1.DEFAULT: Loads the default value of the current input source.
2.LAMP TIMER: Resets the lamp timer. This should only be done after the lamp has been replaced.
3.AUTO OFF: Sets the
4.LAMP HOURS: This displays the number of hours the lamp has been used. (The lifetime of the lamp is 1500 hours.) If lamp usage exceeds 1000 hours, the Lamp indicator light blinks. When the lamp hours reach 1300, a warning message “Lamp!” displays
Menus 25