Basic Operation
Turning the Power on
Follow the steps below.
1.Make sure the Power light is orange when power is applied and the main AC power switch is turned on.
2.Press and hold the POWER ON/OFF key on the remote control or the POWER key on the projector for ONE second to turn the projector on. The POWER light will flash orange while warming up, then show a steady green.
3." Searching…." will be displayed on the screen before the projector identifies the input signal. This message will remain on the screen until a valid signal is detected.
4.If the horizontal frequency of the input signal exceeds the range of the projector (XGA), a message reading " Unsupported timing " will be displayed on the screen. This message will remain
The POWER ON/OFF key on the remote control and the POWER key on the projector may not work while the projector is cooling. (The Power light blinks orange while the projector is cooling.)
Zoom / Focusing
Adjust the projected image to the size that you need using the lens’ zoom ring. Then focus the image by rotating the focus ring.
Focus
Zoom in | Zoom out |
Selecting Input Source
When the projector is turned on, it will search for the input source you last selected.
You may directly select the input source by using the remote control.
18Basic Operation
