Troubleshooting
|
|
| English | |
Problem | Cause | Remedy | ||
| ||||
| There is no power from the power | Plug the power cable into the AC inlet on |
| |
| cable. | the rear of the projector, and plug the |
| |
|
| power cable into to a power outlet. If the |
| |
|
| power outlet has a switch, make sure it is |
| |
|
| switched on. (Page 19) |
| |
The projector does |
|
|
| |
The power switch is not in the on | Put the power switch in the on position. |
| ||
not turn on. |
| |||
position. | (Page 19) |
| ||
|
| |||
|
|
|
| |
| Attempting to turn the projector on | Wait until the cooling down process has |
| |
| again during the cooling process. | completed. |
| |
|
|
|
| |
| The lamp cover is not securely | Correctly attach the lamp cover. (Page 30) |
| |
| attached. |
|
| |
|
|
|
| |
| The video source is not turned on | Turn the video source on and check that |
| |
| or connected correctly. | the signal cable is connected correctly. |
| |
|
| (Page 17) |
| |
|
|
|
| |
| The projector is not correctly | Check the connection. (Page 17) |
| |
No picture. | connected to the input source |
|
| |
device. |
|
| ||
|
|
| ||
|
|
|
| |
| The input signal has not been | Select the correct input signal with the |
| |
| correctly selected. | Source buttons on the remote control or |
| |
|
| SOURCE / ENTER on the projector. (Page |
| |
|
| 19) |
| |
|
|
|
| |
| The connection cables are not | Correctly connect the cables to the |
| |
Image is unstable. | securely connected to the projector | appropriate terminals. (Page 17) |
| |
| or the signal source. |
|
| |
|
|
|
| |
| The projection lens is not correctly | Adjust the focus of the lens using the focus |
| |
| focused. | ring. (Page 20) |
| |
|
|
|
| |
| The projector and the screen are | Adjust the projection angle and direction as |
| |
Picture is blurred. | not aligned properly. | well as the height of this unit if necessary. |
| |
|
| (Page 20) |
| |
|
|
|
| |
| The lens cap is still attached to the | Remove the lens cap. (Page 19) |
| |
| lens |
|
| |
|
|
|
| |
| The batteries are out of power. | Replace both of the batteries with new |
| |
Remote control |
| ones. (Page 10) |
| |
|
|
| ||
There is an obstacle between the | Remove the obstacle. (Page 12) |
| ||
does not work |
| |||
remote control and the projector. |
|
| ||
correctly |
|
| ||
|
|
| ||
| You are too far away from the | Stand within 8 meters (26.2 feet) of the |
| |
| projector. | projector. (Page 12) |
| |
|
|
|
|
Additional information | 33 |
