Best IP29M Series installation instructions Build The Framework

7. BUILD THE FRAMEWORK

!WARNING

When building framework, always follow all applicable construction codes and standards.

The framework must be sized to support the total weight of the hood. Refer to the table below for total weight of the hood, according to the type of blower chosen.

HOOD WIDTH	WITH P6 INTERIOR BLOWER	WITH P12 INTERIOR BLOWER	WITH IN-LINE OR EXT. BLOWERS (ROUGH-IN PLATE ONLY)
42”	71 LB	84 LB	52 LB
54”	86 LB	99 LB	67 LB

7.1SUGGESTED FRAMEWORK FOR INSTALLATION WITH DECORATIVE FLUE COVER AEIWP SERIES

In the ceiling material, cut-out a 28¾” x 12½” max. opening over the installation location. Install two supporting studs inside the cut-out at dimensions shown beside.

	28¾”
	28½”
	SUPPORTING STUDS		Studs flush
12½”			with ceiling material
		125/8”
max.			ceiling	ceiling
			material	material
C		C
L	27”	L
HD0227A

Using provided wood screws no. 10 x 1.5” and washers, assemble both mounting brackets (included with the optional decorative flue cover) to the framework. See illustration beside.

HD0228A

7.2SUGGESTED FRAMEWORK FOR INSTALLATION WITH DRYWALL TRIM ATDIP SERIES

Below is the suggested framework for both 42” and 54” width hoods to be installed with drywall trim ATDIP Series. Refer to the table and illustrations below for the dimensions according to the hood width. Using provided wood screws no. 10 x 1.5” and washers, assemble both mounting brackets (included with the optional drywall trim) to the framework.

HOOD WIDTH	A WITH 5/8” DRYWALL	A WITH 1/2” DRYWALL	B WITH 5/8” DRYWALL	B WITH 1/2” DRYWALL	C
42”	115⁄8”	117⁄8”	285⁄8”	287⁄8”	10” MINIMUM
54”	115⁄8”	117⁄8”	405⁄8”	407⁄8”	10” MINIMUM

FRAMEWORK 42’’ HOOD

HD0235

FRAMEWORK 54’’ HOOD
C	C
L	L
	27¼”
FRAMEWORK	C
TOP VIEW
HD0237

- 8 -