Rear Ports, Cabling | Billion Electric Company 7100SV manual

Billion BIPAC 7100SV VoIP ADSL Router

2.3 The Rear Ports

		LED			Meaning

		Power Switch			A Power ON/OFF switch

		Power Jack			Connect the supplied power adapter to this jack.

		Reset			Press it to restore the factory default setting back.

		VoIP			Connect RJ-11 cable to this port when connecting to an analog phone
		VoIP			set.
					set.

					Connect the supplied Ethernet cable to this port when connecting to a
		LAN			NIC (Network Interface card) in PC.
		(RJ-45			Connect an UTP Ethernet cable to this port when connecting to a LAN
		connector)
					such as an office or home network.

		LINE			Connect the supplied RJ-11 cable to this port when connecting to the
		(RJ-11
		(RJ-11			ADSL
		connector)			ADSL
		connector)

2.4 Cabling

The most common problem associated with Ethernet is bad cabling or ADSL line. Make sure that all connected devices are turned on. On the front of the product is a bank of LEDs. As a first check, please verify that the PWR, LAN and ADSL LEDs are lit and SYS LED is blinking. If they are not, verify that you are using the proper cables.

So long as the cables are connected and the LEDs are lit normally, follow “Chapter 3 Configuration” below to modify the network settings.

6

Image 10

Billion Electric Company 7100SV manual Rear Ports, Cabling

Contents

Bipac 7100SV Page Chapter Appendix Chapter Introduction An Overview of Bipac 7100SV Package Contents Bipac 7100SV Features Introduction Bipac 7100SV Application Front LEDs Lit green when power adapter is connectedLit green when the LAN link is connected Meaning Rear Ports Cabling Before Configuration Configuring PC in Windows XP Billion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows Configuration Billion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings Dhcp server function Information from ISPLAN Port WAN Port IP address IP addresses for Configuring with Web Browser Status Quick Start Status Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status Status- PPP Status LAN Status TCP Status Status- Learned MAC Table Routing Table System Log Security Logs Adsl Quick Start VoIP Quick Start 3.1 WAN Select Adapter Configuration Static IP Settings Service Category Select UBR or CBR Dhcp ClientMAC Spoofing 3.2 LAN Device IP Address VoIP Configuration AuthorizationUserID Same as UserID Service Provider Phone Book Dial Plan Call Feature CallForwarding 3.3.6 PTM Ring Tone Configuration Timer Password System Time Zone Upgrade Factory Setting Restart Firewall Packet Filtering Billion Bipac 7100SV VoIP Adsl Router Bridge Filtering Intrusion Detection Block WAN Request Virtual Server Advanced Adsl 3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Static Route Misc Configuration Testing Ethernet LAN connection Diagnostic TestPPP Half Bridge Default at Disabled Testing Adsl Synchronization Test Ethernet connect to ATM Test ATM OAM Segment Loop BackTest ATM OAM End-to-End Loop Back Test IP connect to PPP Configuration Save Config Problems with the LAN Interface Corrective Action Problems Starting Up the Adsl Router Corrective ActionProblems with the WAN Interface Corrective Action Problems Connecting to a Remote Node or ISP Appendix Contact Billion