Bissell 10N6-F warranty Operations, Power switch, Handle positions, Height adjustment

Operations

Power switch

The Power Switch is located on the left side of the vacuum. Push the rocker switch “ON” (I) to vacuum, and “OFF”

(O) when cleaning is complete.

Handle positions

Press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three cleaning positions.

1.Upright – For storage and above floor cleaning with tools.

2.Normal Cleaning – Press handle release pedal once. Position used for most household floor cleaning tasks.

3.Low Cleaning – With the vacuum in normal cleaning position, press handle release pedal again. Use for reaching under low furniture such as tables, chairs or beds.

Height adjustment

The powerfoot/rotating floor brush on your vacuum can be adjusted to clean several floor surfaces.

NOTE: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting.

1.Turn height adjustment knob to desired setting.

Bare Floor For non-carpeted, indoor surfaces

Lowest Setting	For short pile carpets
Medium Setting	For short and medium
	pile carpets
Highest Setting	For plush pile carpet

Transporting cleaner

1.To move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward.

2.The cleaner can also be moved by using the carry handle.

caution:

To avoid personal injury and to prevent the cleaner from falling when cleaning stairs, always place it at the bottom of the stairs.

1.

2.

3.

Tip:

Before cleaning under low furniture, check area first for objects that might harm the unit or block the vacuum hose.

1.

Height Adjustment Knob

Correct way to

1.carry

6w w w . b i s s e l l . c o m