Bissell 10N6-F warranty Emptying the dirt container, Maintenance and care

Maintenance and care

Emptying the dirt container

The dirt container should to be emptied before the dirt reaches the “Full” line on the container.

1.Unplug the vacuum from electrical outlet.

2.Slide the Lock ‘n Seal Lever to the “Unlock” position.

3.Grasp handle and pull the dirt container straight out to remove from the vacuum.

4.Empty dirt into garbage container.

NOTE: Emptying the dirt container after every use will help prevent over filling and ensure that the vacuum is ready to go the next time you clean.

2.

Unlock

4.

Cleaning the Pre-motor and Post-motor HEPA Media Filter*

1.Unplug the vacuum from electrical outlet.

2.The pre-motor filter protects the motor from dirt particles. It is located in the slide out tray underneath the dirt container. If the filter becomes dirty, pull out the tray, lift out the foam filter pad and clean it.

NOTE: The pre-motor filter may be hand washed in cold water with mild detergent. Rinse well and air dry thoroughly before replacing.

3.The post-motor HEPA media filter* assists in the filtration process to return clean air to the room. It is located behind the door on the side of the vacuum. If the filter becomes dirty, remove the door, remove the filter and replace.

NOTE: The post-motor filter is a white, pleated HEPA Media Filter*. This filter is not washable and must be replaced when it becomes dirty.

Post-Motor

HEPA

Media

Filter*

Washable

Pre-Motor

Filter

NOTICE:

This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty.

*The filter media, not the vacuum as a whole, complies with the IEST-RP-CC001.5 HEPA Standard.

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.

9

w w w . b i s s e l l . c o m