Assembly
The only tool you’ll need to assemble your vacuum cleaner is a Phillips screwdriver.
Attach handle to vacuum
1.Locate the handle and cord wrap. Remove the screw packet taped to the handle.
2.Stand the vacuum upright and from the rear of the unit, slide the base of the handle firmly into the grooves at the top of the vacuum body.
3.Ensure that the handle fits firmly to the vacuum body. If there are any gaps, continue to push firmly until the handle is secure.
4.Insert the provided screw into the existing hole, attaching the handle to the body of the vacuum. Tighten securely with a screwdriver.
Attach vacuum hose and tools
1.Attach the Twist ‘n Snap™ Hose by lining up the tabs on the base with the corresponding notches on the back of the vacuum as shown.
2.Turn the Twist ‘n Snap Hose to the right to lock the hose into place.
3.Grasping the Quick Reach Handle, slide the end of the Hose Wand onto the Hose Wand Base. Snap the Hose into the Hose Clip.
NOTE: The vacuum will not operate effectively unless the hose wand is firmly attached.
4.Slide the extension wand and crevice tool into the storage clip on back of vacuum.
5.Slide the dusting brush/upholstery tool into the storage clip on back of vacuum.
6.Store the Pet TurboBrush™ Tool on the front of the handle by lining up the TurboBrush base with the base of the holder then push back to snap into place.
*The filter media, not the vacuum as a whole, complies with the
2.4.
1.3.
Twist 'n |
|
Snap Hose | 6 |
|
CAUTION:
Before using your vacuum, make sure that the dirt container is in the locked position and that all filters
NOTICE:
For above floor cleaning, the floor brush will continue to rotate, but is raised above floor. To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward.
5
w w w . b i s s e l l . c o m
