Bissell 2SA3 warranty Empty the 2-in-1 water tank/ clean removable nozzle, Lint Screen

Operations

Empty the 2-in-1 water tank/ clean removable nozzle

1.Turn power switch off. Remove the 2-in-1 water tank from the base using the tank carry handle. Carry the tank like a bucket to a utility sink or outside where you will dispose of the collection water. Remove the top of the tank by rotating the handle forward to unlatch lid and lifting lid

off tank.

2.Empty collection water from bottom of tank.

3.After each use, remove and rinse the lint screen located on the tank lid.

4.If nozzle needs to be cleaned: remove by grasp- ing handle at the top and pulling forward. Clean removable nozzle by rinsing under running water.

5.When finished, replace nozzle by slightly raising front of machine to line up slots on the base with the hooks on nozzle. Attach at base first and then click nozzle into place.

NOTE: If nozzle is not attached properly loss of suction will occur.

6.To continue carpet cleaning, refer back to pages 9 and 10, beginning with “Fill the 2-in-1 water tank” on page 9.

If cleaning is complete, refer to the “Maintenance and care” section on page 15.

1.2.

3. Lint Screen 4.

5.

11

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1