Bissell 2SA3 warranty Carpet cleaning, Handle Release, Heater Switch

Operations

Carpet cleaning

1.Plug the deep cleaner into a proper out- let. Set ReadyTools dial to the "FLOOR CLEANING" setting. Turn the power on by pressing the red power switch on the back of the unit with your foot. Turn heater switch (located on side of unit) to the on position. Allow one minute for the built-in heater to warm up before cleaning.

NOTE: The PROheat will be fully warmed and will provide optimal performance after a minute of con- tinuous heated cleaning.

2.With your foot, press the gray handle release lever (located on the back of unit below water tank) to detent handle.

3.While pressing the spray trigger, make one slow forward wet pass and another back. Let the built-in heater, BISSELL 2X advanced deep cleaning formula, and DirtLifter PowerBrush do the work for you.

Caution: Do not overwet.

4.Release the spray trigger and make one slow forward and backward pass over the same area to remove any residual dirty water and aid in drying.

5.Repeat cleaning passes until solution being suctioned up appears clean. Continue passes without pressing the trigger until you can’t see any more water being suctioned up.

Tip: Thorough vacuum- ing before deep cleaning will prevent early clogging of the lint trap.

Handle Release Power Switch

Heater

Switch

WARNING:

To reduce the risk of fire and electric shock due to internal component damage, use only BISSELL cleaning fluids intended for use with the deep cleaner. Non-BISSELL cleaning solutions may harm the machine and void the warranty.

10 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1