Bissell 1693, 8806, 8805 of fire, electric, shock or injury, before servicing, To reduce the risk

How To Clean Upholstery and Small Areas

Important - Check Upholstery Tags

Check manufacturer’s tag before cleaning. “W” or “WS” on the tag means you can use your PowerSteamer If the tag is coded with “X” or “S” (with a diagonal strike through), or says “Dry Clean Only,” do not proceed. Do not use on velvet or silk. If manufacturer’s tag is missing or not coded, check with your furniture dealer.

Check for colorfastness in an inconspicuous place.

If possible, check upholstery stuffing. Colored stuffing may bleed through fabric when wet.

Plan activities to give upholstery time to dry.

Vacuum thoroughly to pick up loose debris and pet hair. Use a vacuum with a brush attachment and a crevice tool to clean in fabric folds and tufts.

Machine Preparation

1. Set up the machine following instructions in The Basics sec- tion, on pages 6-9.

2. Using the Measuring Cup provided, pour BISSELL Advanced Deep Cleaning Formula into the Tank-in-Tank.

3. Set the ReadyTools™ dial to Tools or PreTreat.

Machine Preparation

1. Set up machine following the instructions in The Basics on pages 6-9. Be sure to thoroughly rinse out any remaining Fiber Cleansing Formula from the Tank-in-Tank bottle to prevent slippery linoleum, vinyl, and tile floors. Use BISSELL Hard Floor Solutions in the Tank-in Tank.

2. Check ReadyTools dial - it should be set on Floor Cleaning.

3. Plug into a proper outlet and turn Power Switch ON.

Bare Floor Cleaning Technique

1.	Slowly move the machine nozzle with Bare Floor Tool	WARNING:
	forward and back over soiled surface one time while
	pressing the trigger. Caution: Do not over wet.
	Repeat the motion without pressing the trigger using the	To reduce the risk
2.		of fire, electric
	Bare Floor Tool to squeegee and suction up the dirty water.	shock or injury
3.	Repeat steps 1 and 2 backing along the exit path.	unplug from outlet
4.	Allow about 30 minutes for the floor to dry completely.	before servicing.
	When the cleaning job is complete refer to the Maintenance/
5.
	Storage section on page 11.
6.	To remove Bare Floor Tool gently bend long tab (right
	side) outward and pull tool down away from nozzle.

Rinse thoroughly, dry and store.

Manufacturer’s Tag

10

ug310-5907_1692-1694_205.indd 10 4/18/05 9:20:04 AM