Bissell 8806, 8805, 1693, 1692 How To Clean Carpet, ReadyTools Dial, Pretreating, Normal Cleaning

ReadyTools™ Dial

This provides floor or upholstery cleaning with the turn of a dial. For carpet/floor cleaning make sure the dial is set to FLOOR CLEANING. For upholstery or fabric cleaning, select your cleaning tool, attach it to the Flex Hose, switch to Tools Settings and the PowerSteamer is ready to clean upholstery, fabrics and more*

*Set the switch to FLOOR CLEANING when cleaning carpets, or set it to TOOLS/PRETREAT when using the Flex Hose attachments.

How To Clean Carpet

1.Plan activities to give carpet time to dry.

2.Remove easily moved furniture from the room (chairs, lamps, coffee tables, etc).

3.Vacuum thoroughly to pick up loose debris and pet hair before using the PowerSteamer.

4.Plan your cleaning route to leave an exit path. It is best to begin cleaning in the corner farthest from your exit.

NOTE: You may notice hair and debris deposits on carpet that were loosened by brushing action (especially with newer carpets that have never been deep cleaned before). This debris should be picked up by hand and thrown away. Debris that deposits in the brush belt area should be cleaned out to keep Belts running free.

Pretreating

Improves cleaning effectiveness for heavily soiled carpet in high traffic areas such as entryways and hallways:

1.Set the ReadyTools™ dial to TOOLS/PRETREAT.

2.Plug the PowerSteamer into a proper outlet and turn ON the Power switch.

3.While pressing the trigger, slowly make several passes over the area to be cleaned. Caution: Do not overwet.

Turn the machine Power switch OFF and let BISSELL Advanced

4.Deep Cleaning Formula dissolve the tough soil for 1-2 minutes. Reset the ReadyTools Dial to FLOOR CLEANING before continuing.

Normal Cleaning

EXIT 12

5

4

11

6

3

10

7

9

2

3'

1

START

HERE

4'

1.Plug the PowerSteamer into a proper outlet and turn ON the Power switch.

2.While pressing the Spray Release Trigger, make one slow forward and back wet pass. Let the BISSELL Advanced Deep Cleaning Formula and DirtLifter PowerBrush* do the work for you. Caution: Do not overwet.

3.Release the trigger and make one slow forward and back pass over the same area to remove any residual dirty water.

4.Repeat cleaning passes without pressing the trigger until you can't see any more water being suctioned up.

5.When cleaning job is complete, refer to the Maintenance/

8Storage section on page 11.

Tip:

Thorough vacuuming before deep cleaning will prevent early clogging of the lint trap.

ug310-5907_1692-1694_205.indd 8 4/18/05 9:19:56 AM